Description
Build of Materials
Brass – DZR Brass 352 precision machined bar
O-Rings– twin Nitrile O-Rings Durometer Hardness Duro 70
Washer – Acetyl
Surface Finish – Chrome Plating
Filter – Nylon PA-66 & 304 Stainless Steel 40×40 Mesh Aperture 0.42mm
Flow and Pressure Operation
Operating pressure: Min 20kPa to Max 1600kPa.
Maximum pressure test for pipework pressure testing – up to 2000kPa.
Low pressure: for water pressures below 35kPa remove inline filter – Isovalve™ will have no effect on final flow rates when installed prior to a typical ceramic disc mixer.
At 20kPa a single Isovalve™ will deliver a minimum flow of 6.5L/min.
Operating pressure: At an operating pressure of 500kPa, a single Isovalve™ can deliver a maximum flow of approximately 33L/min.
Operating temperature range: short term minimum 0oC to maximum 90oC. Extended term 60oC.
Certification and Standards
Isovalves and accessories are manufactured and certified to comply with ATS5200.012, AS3688:2005 and ISO5208
DZR Brass complies with AS2345
WaterMark Certification pending.
Guarantee
Every Isovalve™ is factory tested before packaging. Isovalves are guaranteed against defective parts for a period of five (5) years.
Technical Downloads
Link to Technical Specs: IsoTMDuo15
Installation Instructions
IsoTMDuo15
INSTALLATION INSTRUCTIONS
Conventional Install
Slide Wall Flange(IsoWFM) over IsoTap™. Apply sealant to male thread and screw on no more than 10mm. DO NOT OVER-TIGHTEN
OR
Use IsoTap™ both as a tap and a temporary test plug.
The IsoTap™ Range can be used in place of a test plug by simply removing the outlet nipple and tap handle, leaving a cylindrical /lineal plug that can easily have wall linings etc drilled and installed over.
Instructions at Pre-Line Stage
Remove outlet nipple and tap handle. Store carefully ensuring O-rings are not lost.
Plan installation considering finished wall thickness with outlet nipple. Apply sealant and screw on IsoTap™.
Ensure IsoTap™ is closed and turn on water supply.
IsoTMDUO15 can be used to pressure test to 2000 kpa and to flush out pipework. Protect chrome IsoTap™ with masking tape.
Instructions at Final Fit Off
There is no need to turn the water off at a remote location. Slide on wall flange (IsoWFM)
Screw on IsoNipple ensuring O ring and sealing surface is clean. Attach IsoTap™ handle.
Connect fixture. Turn on water at the IsoTap™. Adjust water to desired flow and commission.
10 (IsoN10), 15 (IsoN15) and 20mm (IsoN20) outlet nipples are available, enabling various configurations to suit.
Features:
